![]() Application to big moulds and with the pump of high-capacity. Blured (soft) spot without sharp contour along the perimeter. Application to small moulds of complex geometry and with the pump of low-capacity. It forms the surface of the outer circumference of the annular gap, through which the cementitious slurry follows. Upon request, we will send a link to the scheme of the gun and all parts of which it consists. Use the same link for pricing and spare parts order. ![]() Repair kit for PNS-04 (ПНС-04), only rubber rings. Service life is 10 times longer than steel. Made of high-strength and wear-resistant polyure-thane. Spraying and fiber mixing - up to 1,0 m3/hour at a pressure of 0.2-0.3 MPa (2-3kg/cm2).ģ – air inlet connector (to air-powered drive) ĥ – air inlet connector (to chopper) 7 – mixer lock nut Ĩ – flush fitting 9 – connector with cap nut.Fiber blowing - up to 0,35 m3/hour at a pressure of 0.3-0.6 MPa (3-6 kg/cm2).Three working points require compressed air for operation: The main specifications of RPN-5 range are identical to those of RPN-6. Yes, the difference is only 3.5 mm, but clogging now is less like happening.įiber glass output - from 0.3 to 1.3 kg/minĪdjustable fiber length - 10, 15, 20, 30, 40 mm. Center bore of the fixing cover (cover PNS.04-02.00.05) of mixer has a diameter of 38 mm due to the increased diameter of the external nozzle. Now these nozzles will have to be changed less frequently, as polyurethane will wear out less and longer from the contact with cement and sand solution.Ĥ. The end parts of these nozzles are always subject to wear as they are in continuous contact with shotcrete. These are 2 nozzle options: with or without a knob. The end part of the mixer internal nozzle is rubberized with polyurethane elastomers. Increased sustainability of external nozzle slots, as they are made of wear-resistant polyurethane elastomers.ģ. ![]() It is now possible to change the width of the spraying pattern very quickly by replacing only the external nozzle without mixer rinsing, i.e.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |